Weatherproof telephone or stainless steel panel telephone (14 pages)
Summary of Contents for CEECO SSP-571-D
Page 1
SSP-571-D (FORMERLY 579)-ADA-AA-VA-SPK1.07UNVL-ISSUE4.0 SERVICE MANUAL MODEL SSP-571-D (FORMERLY MODEL SSP-579-D) HANDS FREE PANEL TELEPHONE EQUIPPED WITH SPK1.07 UNVL FIRMWARE WITH OPTIONAL: • ADA FEATURE • AUTO-ANSWER FEATURE • VOICE-ANNOUNCEMENT FEATURE Serving the Telephone Industry Since 1930 Communication Equipment 519 W South Park Street &...
ISSUE 4.0 IMPORTANT INFORMATION CUSTOMER Please fill in before you continue. The following information is necessary when calling CEECO for assistance. MODEL NUMBER MODEL SSP-571-D-ADA-AA-VA, EQUIPPED WITH SPK1.07UNVL FIRMWARE SERIAL NUMBER DATE MANUFACTURED LOCATION INSTALLED For us to better serve you, please have this information available when calling for technical support.
ISSUE 4.0 INTRODUCTION The practices in this manual provide installation and maintenance information for the CEECO Model SSP-571-D-ADA-AA-VA Telephone, equipped with SPK-1.07UNVL firmware. The information in this manual is subject to change without notification. For information not included in this manual, please call or write:...
The CEECO Model SSP-571-D-ADA-AA-VA hands free telephone is a sturdy, vandal resistant, Stainless Steel Speakerphone. Instead of a hookswitch and handset, the SSP-571-D has a Press to start/Press to stop (CALL) button for the initiation and termination of phone calls.
By entering 0 thru 9 into each of the 10 digits, the phone is customized for the particular installation. A selection for all ten Digits must be entered in order for the phone to operate properly. CEECO Communication Equipment & Engineering Company PROPRIETARY...
9, pause approximately one (1) second, and automatically dial the auto-dial number, whenever the CALL button is pressed. #18 ___ ___ ___ ___ ___ ___ ___ ___ ___ ___ ___ CEECO Communication Equipment & Engineering Company PROPRIETARY...
• Speak clearly and loudly into the microphone on the front of the phone. The message can be up to ten (10) seconds in length. • When finished, toggle the record switch to the OFF position. The LED will turn off. CEECO Communication Equipment & Engineering Company PROPRIETARY...
(3) seconds. A normal speakerphone conversation should follow. If the phone was programmed not to allow incoming calls, the microphone will not activate. CEECO Communication Equipment & Engineering Company PROPRIETARY...
Follow these steps: • Call the CEECO phone from another phone. • The CEECO phone answers after the number of ring-counts selected on the auto-answer board (see page16). • The microphone and speaker will activate for remote monitoring and voice transmission.
Run the inside station wire through the housing and terminate on to the RJ11C terminal block on the housing. Please refer to the diagram on the following page. The CEECO modular jack must be used, as it contains required over-voltage protection.
Humidity 20%-90% non condensating. PROGRAMMING: Via DTMF keypad. DIMENSIONS: 6.8" W X 9.76" H X 2.75" D MEMORY RETENTION: Non-volatile memory retention WEIGHT: Approximately 9 Pounds TYPE JACK: RJ11c UL LISTED NO.: 6OF5 CEECO Communication Equipment & Engineering Company PROPRIETARY...
FCC registration number and ringer equivalence number. These numbers are listed in section 7.0. The FCC further requires that you notify your local telephone company when permanently disconnecting this telephone. CEECO Communication Equipment & Engineering Company PROPRIETARY...
10.3 NON-WARRANTY REPAIR CEECO will repair equipment out of warranty for a set charge plus parts. The customer must pay the shipping costs both directions. 10.4 RETURN FOR CREDIT Material may be returned for credit only with prior approval. Material authorized for return is subject to a 20% restocking charge based on the manufacturer's list price.
11.0 WARRANTY POLICY 11.1 GENERAL CEECO products are guaranteed to be free of defects in material and workmanship for a period of 365 days from the date of original purchase. CEECO's obligation under this warranty is limited to repair or replacement of any part found to be defective by CEECO.
ISSUE 4.0 12.0 AUTO-ANSWER DIAGRAM Location of ring-select jumpers, on lower auto-answer board: CEECO Communication Equipment & Engineering Company PROPRIETARY...
BEFORE going off- hook. When programming is completed, move the mini jumpers to the OFF position. NOTE: Do not leave the mini jumpers in the ON position; this will decrease battery life. CEECO Communication Equipment & Engineering Company PROPRIETARY...
Need help?
Do you have a question about the SSP-571-D and is the answer not in the manual?
Questions and answers