Page 1
Issue 4.0 SERVICE MANUAL MODEL WPP-531-FD HANDS FREE WEATHERPROOF TELEPHONE MODEL SSP-531-FD STAINLESS STEEL PANEL TELEPONE EQUIPPED WITH SPK1.07 UNVL FIRMWARE COMMUNICATION EQUIPMENT AND ENGINEERING COMPANY 519 W South Park Street Okeechobee, FL 34972 863-357-0798 Serving The Telephone Industry Since 1930.
Issue 4.0 IMPORTANT INFORMATION CUSTOMER Please fill in before you continue. The following information is necessary when calling CEECO for assistance. MODEL NUMBER MODEL SSP-FD OR WPP-531-FD EQUIPPED WITH SPK1.07 FIRMWARE SERIAL NUMBER DATE MANUFACTURED LOCATION INSTALLED For us to better serve you, please have this information available when calling for technical support.
Issue 4.0 INTRODUCTION The practices in this manual provide installation and maintenance information for the CEECO Model SSP 531-FD or Model WPP-531-FD Telephone with SPK1.07 Universal firmware. The information in this manual is subject to change without notification. For information not included in this manual, please call or write:...
Connect the phone to a working telephone line or a DTMF test set before programming. 3.02 Move the mini-jumpers (located on the CEECO-SPK Printed Circuit Board) to the “ON” position, as depicted on the last page of this manual. 3.03 Press the CALL button and wait for dial tone before programming any digits.
Page 6
1 Dial PBX number stored in location #02. For Emergency Button Digit 10: 0 No Wink Detect l-9 Length of the Wink (l = 50ms incremental to 450ms – entering a 5 is recommended) CEECO Communication Equipment and Engineering Company PROPRIETARY...
Page 7
1 to 11 digits. Any number stored in location #02 will automatically dial first, followed by a pause, then the phone will automatically the number stored in location #01. CEECO Communication Equipment and Engineering Company PROPRIETARY...
Page 8
Allows 1-800 calls. 3.07 When programming is finished, return the mini-jumpers to the "OFF" position. Then return the phone to an “on hook” state (no dial tone), by pressing the black "CALL " button. CEECO Communication Equipment and Engineering Company PROPRIETARY...
Location #70-#79. If the number dialed is not in the Location #70-#79, then the phone gives three tones and drops the line. If digit 1 of Location #00 is "1" then there are no restrictions and any number may be dialed. CEECO Communication Equipment and Engineering Company PROPRIETARY...
DTMF Test Set Volt/Ohm Meter 3/8" Nut Driver 5/16" Nut Driver Flat Blade Screw Driver Security Tool, CEECO Part Number 301-064 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS: 7.01 Using a 301-064 security tool (not supplied) to remove the four locking screws.
Preprogrammed number is automatically dialed (SEE SECTION 2, LOCATION #01) and will not disconnect unless the black “CALL” button is pushed, the called party hangs up and a wink back is received, or a programmed time out disconnect occurs. CEECO Communication Equipment and Engineering Company PROPRIETARY...
12 5/8” High x 9 1/2” Wide x 8” Deep including Door MEMORY RETENTION: Lithium Battery - Long life WEIGHT: 16 Pounds FCC REGISTRATION: BW88T7-13716-TE-T RINGER EQUIVALENCY: 0.4A TYPE JACK: RJ11C U.L. LISTED NO.: 6OF5 CEECO Communication Equipment and Engineering Company PROPRIETARY...
FCC registration number and ringer equivalence number. These numbers are listed in Section 11.00. The FCC further requires that you notify your local telephone company when permanently disconnecting this telephone. CEECO Communication Equipment and Engineering Company PROPRIETARY...
12.03 NON-WARRANTY REPAIR CEECO will repair equipment out of warranty for a set charge plus parts. The customer must pay the shipping costs both directions. 12.04 RETURN FOR CREDIT Material may be returned for credit only with prior approval. Material authorized for return is subject to a 20% restocking charge based on the manufacturer’s list price Return RMA must be requested no later than 30...
13.0 WARRANTY POLICY: 13.01 GENERAL CEECO products are guaranteed to be free of defects in material and workmanship for a period of 365 days from the date of original purchase. CEECO's obligation under this warranty is limited to repair or replacement of any part found to be defective by CEECO.
Page 19
NOTE: NOTE: Do not leave the mini jumpers in the ON position, Do not leave the mini jumpers in the ON position, this will decrease battery life. this will decrease battery life. CEECO Communication Equipment and Engineering Company PROPRIETARY...
Need help?
Do you have a question about the WPP-531-FD and is the answer not in the manual?
Questions and answers