Table of Contents
Advertisement
PROGRAMMING CONTINUED
3.7
If it is necessary for the telephone to automatically dial (Auto Dial) a
number when the "CALL & HANGUP" button is pressed, enter #19,
followed by the desired number. The number may range from 1-11
digits. The time-out disconnect feature (if programmed) will start after
this number has been dialed. If this is not a desired function, please
proceed to the next section.
EXAMPLE: Enter #19 5551212. This will cause the phone to
automatically dial the seven-digit number, 5551212, when the "CALL &
HANGUP" button is pressed.
3.8
If it is necessary for the telephone to automatically dial a PBX or other
access number, enter #18, followed by the desired number. The
number may range from 1-11 digits. Provided that a 1 was entered under
Digit 8 in LOCATION #00, the number stored in location #18 will
automatically dial first, followed by a 1 second pause, and then the
number stored in location #19 will automatically dial. If this is not a
desired function, please proceed to the next section.
EXAMPLE: Enter #18 18001234567. This will cause the phone to
automatically dial the eleven digit 1800 number, followed by a 1 second
pause, followed by the automatic dialing of the number stored in location
#19.
3.9
When programming is finished, press the "CALL & HANGUP" button to
hang up the phone. Return the two mini-jumpers to the "off" or
outermost position, as depicted on the last page of this manual. Secure the
telephone to its mounting. The phone is now ready for use.
4.0
OPERATION
To make a call, press the "CALL & HANGUP" button located on the front of the
telephone and wait to hear dial tone. The LED will illuminate red at this time and
the programmed auto-dial numbers will dial out on the line. The LED will flash
red and green while the call is ringing. When the called party answers, the LED
will turn GREEN after a maximum of four seconds (assuming the ADA feature is
activated). When the call is complete, press the "CALL & HANGUP" button to
hang up the phone. The call will be terminated and the LED will go out.
NOTE: If the telephone is being used to make emergency calls, CEECO cannot
assume responsibility for the called party's response.
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
Issue 4.0
7
Advertisement
Table of Contents
