Recommended Tools And Test Equipment - CEECO SSP-363-F Service Manual

Stainless steel panel telephone

Hide thumbs

Table Of Contents

Table of Contents

TESTING/OPERATION CONTINUED...

4.7

Try placing a call to the phone. If the phone was programmed to accept

incoming calls, it should ring and be answered with normal phone

operation to follow. If it was programmed not to accept incoming calls, it

will still ring, but when it is answered the called party will not be heard on

the far end. The microphone will be muted. The Phone will then sound

an error tone after approximately four seconds and reset itself. If this does

not solve the problem, please refer to section 7.0.

4.8

If the phone was programmed to automatically time and disconnect the

phone call (Call timeout feature), try making a telephone call. Time the

call and see if the phone, in fact, automatically disconnects after the

programmed time period. Please keep in mind that this will not be exact.

If this fails, hang up and repeat sections 3.2, 3.3, 3.5, and 3.10 only. If this

does not solve the problem, please refer to section 7.0.

4.9

Also be sure to determine that the microphone is muting as it was

programmed (Location #00) and that the phone is in either DTMF (tone)

dialing mode or pulse dialing mode as programmed (Also Location #00).

DTMF sounds like definite tones or beeps, whereas pulse-dialing sounds

like rhythmic clicks. If the phone does not seem to be functioning as

programmed, hang up and repeat sections 3.2, 3.3, 3.5, and 3.10 only. If

this does not solve the problem, please refer to section 7.0.

4.10

Attempt to "hookswitch dial" by tapping quickly on the tongue of the

hookswitch assembly. The phone should momentarily open the line, until

the attempt is over, and then return dial tone. If not, please refer to section

7.0.

5.0