Fig. 8-12: Location Of The Hard Disk With Damper - Bosch REXROTH VSB 40.1 Project Planning Manual

VSB 40.1
DOK-SUPPL*-VSB*40.1***-PR02-EN-P
Exchanging Hard Disk with Damper
In case of VSB devices containing hard disks with damper, the hard disk
is located below the device, refer to Fig. 8-12.
Fig. 8-12: Location of the hard disk with damper
In order to exchange the hard disk, remove the fastening screw of the
hard disk installation frame on the bottom side of the VSB 40.1 (refer to
Fig. 8-13). Lift the hard disk frame and after releasing the retaining spring
unplug the ribbon cable, with which the hard disk is connected to the main
board. Now, the installation frame with hard disk can be removed and can
be exchanged as whole unit.
Fig. 8-13: Position of the hard disk's installation frame and the fastening screw
Maintenance and Installation
Position_der_schwingungsgedaempften_Festplatte.EPS
Fastening screw
Installation frame for hard disk
Festplattentausch.FH11
8-9