Fig. 8-5: Fastening Screws Of The Hard Disk Frame; Fig. 8-6: Lifted Hard Disk Frame - Bosch REXROTH VSB 40.1 Project Planning Manual

VSB 40.1
DOK-SUPPL*-VSB*40.1***-PR02-EN-P
7. Loosen the fastening screws of the hard disk frame. The hard disk
and (depending on the device design) the CD DVD drive are mounted
on this plate:
Fig. 8-5: Fastening screws of the hard disk frame
8. Lift the hard disk frame:
Fig. 8-6: Lifted hard disk frame
9. Loosen the two cables (IDE and power supply) from the hard disk.
10. Now, remove the old and insert the new hard disk.
11. Connect the two cables. Observe that you don't bend the connection
pins.
Note: Check the cable connections leading to the hard disk for
tightness.
12. After having re-connected the cables, put the hard disk frame into the
housing by using the claws provided at its bottom. While closing the
housing, observe not to squeeze any cables.
13. Fasten the hard disk frame with the two screws.
14. Put the VSB 40.1 in the mounting plate (mounting frame) and fix it
with the four screws.
15. The new hard disk parameters are automatically recognized by the
system. If the operating system does not boot automatically after
switching on the VPB, interrupt the power supply for at least 10
seconds and restart.
Maintenance and Installation
83_Laufwerk2.JPG
8-5
83_offen.JPG