Fig. 8-4: Loosen The Fastening Screws At The Mounting Frame - Bosch REXROTH VSB 40.1 Project Planning Manual

8-4
Maintenance and Installation
Note: The hard disk to be inserted must already have an installed
operating system, if no external boot medium is connected to
the industrial PC. In any case, it is recommended to have a
completely installed operating system on the hard disk, to
shorten the installation time!
The change of the hard disk for the two variants is not identic, as the hard
disk is located at different positions.
Changing the Hard Disk of the VSB 40.1, Variant NN
1. Save all required user data as well as the operating system settings
of your system on an external storage medium or via the network
connection!
2. Shutdown the operating system.
3. Wait until the power supply unit switches off and then, switch off the
supply voltage. If required, unplug all connectors.
4. Put the VSB 40.1 on a solid mat, so that the connector panel looks in
your direction.
5. Loosen the four screws with which the hard disk frame is fixed at the
VSB 40.1:
Fig. 8-4: Loosen the fastening screws at the mounting frame
6. Remove the VSB 40.1 from the mounting plate (mounting frame), so
that it is turned away from you.
VSB 40.1
83_Gehäuse.JPG
DOK-SUPPL*-VSB*40.1***-PR02-EN-P