Bosch REXROTH VSB 40.1 Project Planning Manual page 77

12-2
List of Figures
Fig. 7-15:Pin assignment of the 230/115 VAC connection X20 7-13
Fig. 7-16:Technical data 115/230 VAC connection 7-13
Fig. 7-17:Voltage connection 230 VAC via isolating transformer 7-14
Fig. 7-18:Pin assignment RS232, D-sub male connector, 9-pin 7-15
Fig. 7-19:Serial interface adapter XCOM4 on slot for extension card A6 7-
15
Fig. 7-20:Pin assignment RS232, D-sub male connector, 9-pin 7-16
Fig. 7-21:Pin assignment RS232, D-sub male connector, 9-pin 7-16
Fig. 7-22:Serial interface adapters XCOM3 and XCOM4 on the slots for
the extension cards A5 and A6 7-16
Fig. 7-23:Pin assignment RS232, D-sub male connector, 9-pin 7-17
Fig. 7-24:Pin assignment RS 422, D-sub male connector, 9-pin 7-17
Fig. 7-25:Serial interface adapters XCOM3 and XCOM4 on slot for
extension card A6 7-17
Fig. 7-26: Position of the connections and the jumper on the motherboard
variants 7-18
Fig. 7-27:Jumper positions for termination settings 7-18
Fig. 7-28:Pin assignment RS232, D-sub male connector, 9-pin 7-19
Fig. 7-29:Pin assignment RS422 (here the Rexroth standard assignment),
D-sub connector, 9-pin 7-19
Fig. 7-30:Serial interface adapters XCOM3 and XCOM4 on slot for
extension card A6 7-19
Fig. 7-31: Position of the connections and the jumper on the motherboard
variants 7-20
Fig. 7-32:Jumper positions for termination settings 7-20
Fig. 8-1: Connection of the UPS 8-2
Fig. 8-2: View of the UPS inserted in the holder 8-2
Fig. 8-3: Installation dimensions UPS holder 8-3
Fig. 8-4: Loosen the fastening screws at the mounting frame 8-4
Fig. 8-5: Fastening screws of the hard disk frame 8-5
Fig. 8-6: Lifted hard disk frame 8-5
Fig. 8-7: Loosen the fastening screws at the mounting frame 8-6
Fig. 8-8: Loosen the VSB 40.1 from the mounting plate 8-6
Fig. 8-9: Tip the VSB 40.1 to the left and remove it from the mounting
plate 8-7
Fig. 8-10:Loosen the cable from the hard disk 8-7
Fig. 8-11:Loosen the fastening screws of the hard disk 8-8
Fig. 8-12: Location of the hard disk with damper 8-9
Fig. 8-13: Position of the hard disk's installation frame and the fastening
screw 8-9
Fig. 8-14:Loosen the fastening screws of the cover 8-10
Fig. 8-15:Lift the cover with fan 8-11
Fig. 8-16:Remove extension card 8-11
Fig. 8-17:Fix the new PCI card with the screw 8-12
Fig. 9-1: UPDD setup programs for the touch screen 9-1
Fig. 9-2: Dialog window to set the touch screen 9-2
Fig. 11-1:Type code designation VSB 40.1 11-1
VSB 40.1
DOK-SUPPL*-VSB*40.1***-PR02-EN-P