Display And Operating Components; Power Button; Display, Monitor And Keyboard; Display - Bosch REXROTH VSB 40.1 Project Planning Manual

VSB 40.1
6

Display and Operating Components

6.1

Power Button

6.2

Display, Monitor and Keyboard

Display

VGA Monitor

Selection of the Graphic Driver

DOK-SUPPL*-VSB*40.1***-PR02-EN-P
Besides the connector panel (see Fig. 7-1) a button labeled with "PWR" is
provided.
Usually, this power button has no function, as the VSB 40.1 is started by
applying the supply voltage. This is preset in BIOS. If the BIOS setting has
been modified by accident, the VSB 40.1 can be started by pressing this
button.
To reset the original status, in which the VSB 40.1 also starts without
pressing the power button immediately after applying the supply voltage,
activate the BIOS setup during the booting process with the <Entf> or
<DEL> key. There, activate menu "Power Management Setup". Select in
this menu under item "PWRON After PWR-Fail" the setting "[Former-
Sts]".
To display and operate the VSB 40.1 we recommend the displays VDP 16
and VDP 40 especially designed by Bosch Rexroth for industrial
applications. The displays are connected with the VSB 40.1 via the G4
display interface. Hence, you can install the display 30 meters away or
more from the PC. The VDP-type displays are equipped either with a
keypad or with a touch screen.
Note: Detailed information can be found in the corresponding
documentation of the VDP 16 device and the VDP 40.
You can also connect mouse and keyboard to this displays.
You can connect a standard monitor (female connector XVGA), a PS2
keyboard (female connector XKB) and a PS2 mouse (female connector
XMS) with the VSB 40.1.
Note: If a VDP is used, keyboard and mouse can be connected to it
only. The interface for keyboard and mouse must remain free.
When the VSB device is delivered, the settings allow to trigger both a
connected monitor and a connected VDP.
Display and Operating Components
6-1