Omron NA5-15W101S-V1 User Manual page 66

3 Installation and Wiring
Slide the PWA over the NA Unit from the back until the flat side of the PWA is flat against the
inside of the panel, as shown in the following figure.
3
Attach the panel mounting brackets from the back of the panel as shown in the following figure.
The number of mounting brackets depends on the size of the NA Unit, as shown in the following
table. Refer to Bracket Mounting Locations for Different Units on page 3-8.
Model
NA5-15W-V1
NA5-12W-V1
NA5-9W-V1
NA5-7W-V1
Catch the brackets in the mounting holes in the NA Unit, pull forward lightly, and then use a Phil-
lips screwdriver to tighten the screws and secure the NA Unit to the panel, which will be held
between the mounting brackets and the NA Unit.
3 - 6
Number of Panel Mounting Brackets
8 locations
6 locations
4 locations
4 locations
Locations to Catch the
Mounting Brackets (Side View)
Panel
NA-series Programmable Terminal Hardware(-V1) User's Manual (V125)
Optional High-pressure
Waterproof Attachment (PWA)
Mounting bracket
NA Unit
mounting holes
View without PWA