Stairmaster 10G Owner's Manual page 10

Fan Button
Numeric
Keypad
Up/Down
Buttons
FUNCTION NOTE: This machine has a safety feature to help prevent users from accidentally increasing the
machine speed to a level that is too high for them. When pressing the level up button to increase speed, there
are two stop points at level 10 and level 15 which function as follows: when increasing level, the machine will
not allow the user to increase the level past the stop point until the actual machine speed has reached the set
level. For example, if a user is at level 5 and repeatedly pressed the level up button, it will allow the set level to
go up to level 10, but no further until the actual machine speed has reached level 10. Once the machine speed
has reached the set level, the user can increase the level further.
BLUETOOTH DEVICE PAIRING
Bluetooth Device Pairing with Bluetooth Button: Pushing the button puts the console into
discover mode. The console will be available for pairing for up to 60 seconds to pair with a
compatible App. The button will flash while searching for pairing, and the display will show the
unique console code. Once a device is paired with the console, the light will stop flashing and
remain on to indicate the connection. Visit our website for a list of compatible Apps.
Pairing with Apple Watch: OpenHub consoles marked with this icon
capability to connect using Near Field Communication (NFC) with Apple Watch (must be
running WatchOS 4.2 or later and have option Detect Gym Equipment set to On in Watch settings for
Workout App.)
Pairing with Samsung Galaxy Watch: OpenHub consoles marked with the Samsung
icon also have the capability to connect with Samsung Galaxy Watch (must be running
software 4.8 or later and have NFC set to On)
To connect: Hold the watch near the
the display and watch detect each other, the Bluetooth button on the display will flash and then turn solid blue,
and watch will ask user to confirm connection with the display. Once connection is confirmed by user, it will
finalize and data will begin to pass between console and watch. It is possible to make this connection either
before the workout begins (recommended), or at any time during an active workout. At the end of workout, the
connection will be terminated.
Note: when Apple Watch is connected to display, the Calories display window will show both Active and Total
Calories per Apple Watch calculations.
1 See support.corehandf.com/Software for version numbers and update instructions
Cycles the fan between three settings: High, Low and Off
Use to enter specific values for program parameters during program setup.
During a program, these keys may be used to change level.
Cycle between options during setup mode, adjust level up and down during workout mode
.
1
icon on the console (this is where the NFC reader is located). When
have the
Page 9