Husqvarna K1270 Workshop Manual page 78

Handle
21.6. THROTTLE
1. Pull up the throttle until it stops.
2. Raise the white lever for the throttle wire and
place it in the position shown.
3. Press the unit at a slight angle to the side,
as shown, and at the same time work out the
handle. Relatively strong force is needed.
4. Remove the throttle.
21.7. INSTALLING THE THROTTLE
1. Fit the throttle wire to the throttle.
2. Put the throttle in place with the white lever up.
Slide the unit in a little.
3. Fold in the white lever in the notch on the
throttle.
4. Press the unit completely in position for fitting
of the shaft.
5. Fit the shaft from the right side of the machine,
as seen from behind. Knock in the shaft with a
pin punch and a small hammer.
78
- English
HANDLE - REMOVE THE THROTTLE STEP 1 AND 2
HANDLE - REMOVE THE THROTTLE STEP 3 AND 4
HANDLE - INSTALLING THE THROTTLE STEP 1 AND 2
HANDLE - INSTALLING THE THROTTLE STEP 3 AND 4
HANDLE - INSTALLING THE THROTTLE