Husqvarna K1270 Workshop Manual page 64

Crankcase
17.6. CRANKSHAFT
TOOLS
Use the tool kit 544 10 36-02 to press the crank-
shaft into the bearing, after first fitting this in the
relevant crankcase half.
The threaded mandrel for the clutch and flywheel
side is M12V and M10x1, respectively.
ASSEMBLY
1. Attach the crankcase half in a vice with soft
jaws.
2. Push the crankshaft in all the way by hand. Use
the support plate to hold the connecting rod in
an upright position.
3. Position the sleeve from the tool kit against
the crankcase half. Screw the threaded fitting
M12V on the crankshaft by hand until it
bottoms.
NOTE! The crankshaft has a left-hand
thread on the clutch side.
4. Lock the threaded mandrel's movement and
press in the crankshaft by turning the nut until
the bearing reaches the stop in the crankcase
half. Make sure that the connecting rod is not
held against the crankcase half.
5. Fit the guides.
6. Fit the new crankcase gasket.
64
- English
CRANKSHAFT ASSEMBLY
CRANKSHAFT ASSEMBLY
CRANKSHAFT ASSEMBLY