Husqvarna K1270 Workshop Manual page 73

REMOVE THE BEARINGS FROM THE AXLE
4. Remove the bearings using a universal puller.
ALTERNATIVE 1: FITTING WITH PRESS
5. Support the bearing housing under the area for
the bearing with, for example, a piece of wood
so that the bearing housing is horizontal.
6. Put the bearing in place and position the
pressing device (C) on top of the bearing.
Push down the bearing fully to the stop in the
bearing housing, as shown in the detail picture.
NOTE! If the bearing is knocked into place,
there is a great risk that the bearing will
enter at an angle into the bearing housing
causing damage. Use screw press 506 37
61-02 instead.
ALTERNATIVE 2: FITTING WITH SCREW PRESS
The bearing press 506 37 61-02 is the best assem-
bly tool for fitting the first bearing if the hydraulic
press is not available.
5. Fit the tool as per the illustrations. Note that the
support washer, shown in the bottom illustra-
tion, have different guides. The larger diameter
provides firm support to the bearing housing.
5. Screw in the bearing fully to the stop in the
bearing housing.
BEARINGS REPLACEMENT - REMOVE BEARING
BEARINGS REPLACEMENT - FITTING WITH PRESS
BEARINGS REPLACEMENT - FITTING WITH SCREW PRESS
Cutting head
73
English -