Husqvarna K1270 Workshop Manual page 62

Crankcase
IF THE BEARING DOES NOT RELEASE FROM
THE CRANKCASE
Normally the bearing should release from the
crankshaft during dismantling.
The bearing is dismantled from the crankshaft
using the puller 531 00 48-67.
1. First fit the puller plate behind the bearing.
2. Then fit the puller unit and press the bearing off
of the crankshaft.
17.5. MAIN BEARING
TOOLS
Use the tool kits 506 37 61-02 and 544 10 36-02 to
change the main bearing.
DISMANTLING
NOTE! The tubular guides for the crankcase
halves must be removed!
1. Place the crankcase halves against a flat piece
of wood or the like.
2. Heat around the bearing with a hot air gun,
max. 300 °F/150 °C.
62
- English
PULLER PLATE
PULLER UNIT
HEAT AROUND THE BEARING