Husqvarna K1270 Workshop Manual page 20

Dismantling into basic modules
5. Loosen the hoses by the water valve. Lift off
the belt from the pulley and remove the cutting
head.
6. Loosen the bolt on the rear belt guard.
(Tightening torque when assembling 6.6–8.1
lbf·ft/9–11 Nm.)
7. Remove the guard. At this stage, the belt can
be replaced.
7.4. CUTTING ARM
1. Remove the nut and the three screws.
2. Lift off the cutting arm. Check when reassem-
bling that the two pipe guides are in place.
20
- English
DISMANTLE CUTTINGHEAD STEP 5
DISMANTLE CUTTINGHEAD STEP 6-7
CUTTING ARM