Husqvarna K1270 Workshop Manual page 29

DISMANTLING/ASSEMBLING
The starter pawls are fitted using a shoulder screw.
Note the position of the springs in relation to the
flanges on the flywheel so that they are fitted
correctly.
NOTE! Do not forget the washer (A) that should
lie under the starter pawls against the flywheel.
ASSEMBLY
NOTE! It is important that the spring does not
get caught between the starter pawls and the
flywheel.
The following method is recommended when
assembling:
1. Press the spring into position in the flywheel.
2. Fit the washer.
3. Screw on the starter pawls.
4. Make the simplest of "special tools":
Bend the end of a thin steel wire and use this
to pull the spring under the starter pawls to the
mounting on the opposite side.
FITTING THE STARTER
Do as follows so that the starter pawls come into
the right position against the starter pulley sleeve:
First pull out the cord about a half meter. Keep
this position when the starter is set against the
machine and slowly release and the starter pawls
will take on the correct position.
Tighten the four screws on the starter to a torque
of 5–6.5 lbf·ft/7–9 Nm.
ASSEMBLY STARTER PAWL
STARTER PAWL SPRING TENSION
FITTING THE STARTER
Starter
29
English -