Husqvarna K1270 Workshop Manual page 23

7.8. AIR DUCT
1. Dismantle the entire air filter unit, cylinder
cover and starter. Note how the cable to the
stop switch and the ignition lead are fitted in
the air duct.
2. Loosen the ignition lead from the spark plug
and release the cable from the air duct.
3. Loosen the cable lug on the ignition module
and the stop switch. Remove the air duct.
7.9. MUFFLER
1. The cutting head, the cutting arm, the cylinder
cover and the air filter must be dismantled
before dismantling the muffler .
2. Release the two mounting screws holding the
muffler i position.
3. Release the thre screws in the muffler support
plate.
4. Remove the muffler.
ASSEMBLY
The insulating fibre gasket must be placed
between the muffler and heat shield.
The heat shield must be next to the cylinder,
without gasket.
7.10. INLET MANIFOLD
The connection between the carburettor and the
cylinder is flexible to minimize vibrations and heat
transfer to the carburettor.
1. Unscrew the four mounting screws holding the
cylinder. Remove the cylinder. by lifting it up.
Dismantling into basic modules
REMOVE THE AIR DUCT
DISMANTLE MUFFLER
INLET MANIFOLD
23
English -