Mitsubishi Electric MELSEC iQ-R Series Introduction Manual page 71

Jump to a device/label
Check the workpiece heights at the positions where the log markers are made.
1.
Double-click the workpiece height real number in the data flow analysis.
2.
Jump to the label in which the workpiece height read with the sensor is stored.
3.
With the and buttons, perform the frame-by-frame playback of the positions where the log markers have been
made. Check the workpiece height at each position where the log marker has been made.
The real number value at the
position where the logo mark
is made can be checked.
The frame-by-frame playback
can be performed at the positions
where the logo marks are made.
7 OPERATION EXAMPLE
7.1 How to Check the Recording Result
7
70