U-Line UHDE215 User Manual & Service Manual page 15

USER GUIDE
4. Attach other end of hose to the single connection
within the beverage tower.
Other end is
connected
to Infuser
Regulator
Connect Nitrogen Tank to Keg
1. Attach nitrogen line to ball valve on tank regulator.
Make sure valve is in the off position - turned
clockwise as far as it can go. Tighten hose clamp.
2. Attach other end of nitrogen line to T connector on
infuser regulator - line up and press in firmly.
T-Connector
General Installation
3. Attach gray coupler of the gas jumper line to keg.
With your thumb on top of the coupler, pull up on
collar and press coupler down firmly onto in valve.
Release collar - listen for a click. Pull up on the
coupler to ensure it is locked down.
In Valve
4. Attach other end of gas jumper line to T connector on
infuser regulator - line up and press in firmly.
T-Connector
15
u-line.com