Advertisement
10 Line
Cylindrical Lockset
Installation Instructions
Lever Removal & Installation
7
Standard Cylinder (Figure 9)
To Remove:
Rotate key 45° and hold. Depress lever catch with pin tool.
To Install:
Insert key and rotate 45° clockwise, slide the lever on. Confirm the lever will not pull off.
Interchangable or Removable Core (Figure 10)
To Remove:
Remove cylinder and tailpiece, using control key (stamped "C"). Insert Phillips #2 screwdriver into cylinder
opening and make contact with lever catch. Pull lever catch horizontally towards door hinge and remove
lever.
To Install:
Slide lever over lever catch. Confirm the lever will not pull off.
*Note: For 1-Bitted cylinders, utilize a control key cut 113511.
8
Standard Cylinder Installation
IMPORTANT
10G16, 10G30, 10G54 Functions:
• Before installing cylinders, use a flat-bladed screwdriver to rotate all cams
counterclockwise until they stop (Figure 11). (Cam is located in lever support
tube of lockbody). (Figure 12)
10G26 & 10G38 Functions:
• See supplemental instruction sheet A8082.
Interchangeable or Removable Core
•
Remove temporary construction core or plastic core. If keyed, use Control Key
(stamped "C") rotate 15° and pull.
•
Insert permanent core into lever with control key; rotate 15° and remove key.
IMPORTANT
•
Remove tailpiece from construction core and insert into new core. If using 7 pin cores,
insert the 7 pin tail piece that's supplied with the lock, before installing the core into the lock.
•
For Degree and XC LFIC cores, retainer must be installed on tailpiece.
1-800-727-5477 • www.sargentlock.com
Copyright © 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in part
without the express written permission of SARGENT Manufacturing Company is prohibited.
Figure 11
Lever
Support
Tube
Washers
(only 30-option)
Cam
New Cylinder
Lever catch
Cylinder
Spacer
Cylinder
Remove
Construction Core
Remove/Reuse 6 Pin Tailpiece
Plastic Core
Construction Core
SFIC Shown
3
Figure 9
Control Key*
Figure 10
Figure 12
Key
r
Outside Lever
Correct Key Orientation
During Assembly
Install New/
Final Cylinder
Keyed
Core
7 Pin
In Core
Keyed
Core
6 Pin
In Core
A7133 12/20
Advertisement
