Wiznet WizFi360 User Manual page 36

+CIPAP_DEF˖<ip>
+CIPAP_DEF˖<gateway>
Response
+CIPAP_DEF˖<netmask>
OK
• <ip>: string parameter, the IP address of the WizFi360 SoftAP.
•
[<gateway>]: gateway.
Parameters
•
[<netmask>]: netmask.
• The configuration changes will be saved in the flash
• Currently, WizFi360 only supports class C IP addresses.
•
The Set Command interacts with DHCP-related AT commands
(AT+CWDHCP-related commands)˖
Notes
- If static IP is enabled, DHCP will be disabled;
- If DHCP is enabled, static IP will be disabled;
- Whether it is DHCP or static IP that is enabled depends on the last
configuration.
AT+CIPAP_DEF="192.168.10.100","192.168.10.1","255.255.255.0"
Example
10.2.2.23. AT+CIPSTAMAC_CUR
Station Configuration Not Saved in the Flash
Commands AT+CIPSTAMAC_CUR?
+CIPSTAMAC_CUR˖<mac>
Response
OK
• <mac>˖string parameter, MAC address of the WizFi360 Station
Parameters
• The configuration changes will NOT be saved in the flash.
• The MAC address of WizFi360 SoftAP is different from that of the WizFi360
Station. Please make sure that you do not set the same MAC address for both of
Notes
them.
• Bit 0 of the WizFi360 MAC address CANNOT be 1
AT+CIPSTAMAC_CUR="00:08:DC:36:00:0C"
Example
10.2.2.24. AT+CIPSTAMAC_DEF
Station; Configuration Saved in the Flash
Commands AT+CIPSTAMAC_DEF?
WizFi360 User Manual
OK
Sets the MAC Address of the WizFi360
AT+CIPSTAMAC_CUR=<mac>
OK
Sets the MAC Address of the WizFi360
AT+CIPSTAMAC_DEF=<mac>