Wiznet WizFi360 User Manual page 35

• [<netmask>]: netmask.
• The configuration changes will be saved in the flash.
• Currently, WizFi360 only supports class C IP addresses.
• The Set Command interacts with DHCP-related AT commands
(AT+CWDHCP-related commands)˖
Notes
- If static IP is enabled, DHCP will be disabled;
- If DHCP is enabled, static IP will be disabled;
- Whether it is DHCP or static IP that is enabled depends on the last
configuration.
AT+CIPAP="192.168.10.100","192.168.10.1","255.255.255.0"
Example
10.2.2.21. AT+CIPAP_CUR
Configuration Not Saved in the Flash
Commands AT+CIPAP_CUR?
+CIPAP_CUR˖<ip>
+CIPAP_CUR˖<gateway>
Response
+CIPAP_CUR˖<netmask>
OK
• <ip>: string parameter, the IP address of the WizFi360 SoftAP.
•
[<gateway>]: gateway.
Parameters
•
[<netmask>]: netmask.
• The configuration changes will not be saved in the flash
• Currently, WizFi360 only supports class C IP addresses.
•
The Set Command interacts with DHCP-related AT commands
(AT+CWDHCP-related commands)˖
Notes
- If static IP is enabled, DHCP will be disabled;
- If DHCP is enabled, static IP will be disabled;
- Whether it is DHCP or static IP that is enabled depends on the last
configuration.
AT+CIPAP_CUR="192.168.10.100","192.168.10.1","255.255.255.0"
Example
10.2.2.22. AT+CIPAP_DEF
Configuration Saved in the Flash
Commands AT+CIPAP_DEF?
WizFi360 User Manual
Sets the IP Address of the WizFi360 SoftAP,
AT+CIPAP_CUR=<ip>[,<gateway>,<netmask>]
OK
Sets the IP Address of the WizFi360 SoftAP,
AT+CIPAP_DEF=<ip>[,<gateway>,<netmask>]