Set Up - Bryant Evolution Connex Control Installation Instructions Manual

Touch Airflow Verification Test to perform a duct assessment. This can be done if duct
modifications have been made since installation of the Evolution Connex Control. Duct
assessment can be performed without performing a full system install.
NOTE: This feature is only available with specific ICP communicating indoor units. See the
Ion System Control Product Data for compatible units and more information.
NOTE: For Small Packaged Products (SPP), please use the following instructions for Set-up
(Set-Up Section), Checkout (Checkout Section), and Service (Service Information Section):
– For PAC AC Indoor and OAC HP Indoor, follow Fan Coil instructions.
– For Gas PAC Indoor and Gas PHP Indoor, follow Furnace instructions.
– For all PAC Outdoor, follow AC/Heat Pump instructions.

6.3. Set up

NOTE: Depending upon the equipment installed, the following options will be displayed. See
the Evolution System HVAC equipment Installation Instructions for more details, as provided.
• Indoor:
– Furnace
– Fan coil
– PAC AC Indoor
– PAC HP Indoor
– GAS PAC Indoor
– GAS PHP Indoor
• Outdoor:
– AC/Heat pump
• Geo HP
• PAC AC outdoor
• PAC HP outdoor
• GAS PAC outdoor
• GAS PHP outdoor
Once the equipment has been selected, the appropriate menus will be displayed.
22
A13130