Optional Brick Panels; Log Set Installation - Regency Panorama PG33NG4-R Owners & Installation Manual

Gas inbuilt
Table of Contents

Advertisement

installation
OPTIONAL BRICK
PANELS
1) Undo the bottom 2 door latches and open and
remove glass door. Remove logs.
2) Attach the 2 Rear Brick Retaining clips to the
rear wall. Loosen the screws in the top and
rear wall of the firebox and slide the retaining
clips into position (tight against the firebox top)
and then tighten the screws.
Note: The logs must not be in the unit.
3) Insert the back brick panel by carefully slipping
it between the back wall of the firebox and the
rear log bracket.
4) Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.
5) Slide the Top Brick Panel into position and slide
the Top Brick Retaining clips so that they hold
the Top Brick Panel in place and tighten down
the screws.
26

LOG SET INSTALLATION

E) 252
Front Right Cross Log
902-252
F)
E m b e r s
902-156
G)
Vermiculite
902-179/21
H)
Rockwool
The 3-digit numbers (i.e. 250) are
molded into the rear of each log.
902-153
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
Read the instructions below carefully and
refer to the diagrams. If logs are broken do not
use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
Log Kit # 431-930 contains the following pieces:
A) 250
Rear Log
B) 254
Middle Cross Log
C) 253
Front Left Cross Log
D) 251
Rear Left Log
Vermiculite
Vermiculite
2) Sprinkle the vermiculite and embers around
the firebox base.
3) Place the Log 250 on the rear log support
250
D) 251
C) 253
pins with the flat side to the back.
4) Place Log 254 on the front right side of the
burner. Push the back of the log against the
2 brackets with the notch on the bottom right
side of the log fitting into the right side of
the grate.
Bracket
902-250
902-254
902-253
902-251
250
254
5) Position Log 253 across the cutouts in Logs
250 and 254 with the notch on the left side
Vermiculite
of the log fitting into the 2nd grate tab.
2nd Grate Tab
Regency PG33NG4-R Gas Inbuilt
A) 250
B) 254
E) 252
Notch
254
Bracket
Cutouts
253
250
254

Advertisement

Table of Contents
loading

This manual is also suitable for:

Panorama pg33lpg4-rPanorama pg33ulpg4-r

Table of Contents