Table of Contents
Advertisement
6) Place the bottom left front edge of Log
251 against the left edge of the burner tray
and rest the log on the cutout on Log
253.
250
251
7) Position Log 252 across the cutouts in Logs
254 and 253. The notch in the bottom right
end fitting against the 5th grate tab.
254
5th Grate Tab
251
254
Regency PG33NG4-R Gas Inbuilt
8) Pull off ember size pieces of rockwool and
gently place them on the front of the burner
tray in the places shown in the photo below.
Do not compress the rockwool, leave it loose.
250
9) Test fire to ensure proper light off (make
254
Place rockwool in these 2 locations
sure flame flows smoothly from one end of
burner to the other). If there is any flame
hesitation, check that area for any blockage
of the burner ports.
254
10) Install flush glass and bay glass (if used) as
per instructions in this manual.
Cutout
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd spring. See diagram 3.
To remove the flush door, reverse the above
steps.
Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then
attach trim to the top and bottom of Flush door.
250
on the burner tray.
Optional Flush Trim
installation
Diagram 1
Diagram 2
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located
Diagram 3
underneath the top of the firebox.
2) Install the bottom louver by folding the louver
down and then sliding the Bottom Louver
bracket down onto the 2 pins on the base
of the unit (dia. 1). Secure with 1 screw as
per diagram 2.
Note: Top and bottom louvers are different.
27
Advertisement
Table of Contents
