Table of Contents
Advertisement
INSTALLATION
S.I.T. Valve Description
1) On-Off Solenoid Valve EV1
2) On-Off Solenoid Valve EV2
3) Inlet Pressure Test Point
4) Outlet Pressure Test Point
5) Connection for Pressure Regulator/
Combustion Chamber Compensation
6) Pressure Regulator for Minimum and
Maximum Outlet Pressure
7) Gas Outlet Pressure Electric Modulator
8) Pilot Outlet
9) Main Gas Outlet
10) Side Outlet
22
OPTIONAL
BRICK PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2) Insert the back brick panel fi rst by carefully
slipping it between the back wall of the
fi rebox and the rear log bracket.
3) Put the side panels in next. Slide them in
from the front and push them fl at up against
the wall. Be very careful not to scratch them
on the fi rebox hardware.
4) Install the 2 brick retaining clips, one on
each side.
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit (Part # 780-930) contains the
following pieces:
a) 02-75
Rear Log
b) 02-55
Middle Left Log
c) 02-50
Front Left Log
d) 02-53
Center Left Log
e) 02-51
Front Bottom Log
f)
02-54
Center Right Log
g) 02-52
Middle Right Log
h)
Embers
02-55
02-75
02-50
02-53
02-51
The "02" refer numbers (i.e. 02-75) are
molded into the rear of each log.
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite all over the top of
the base brick panel.
3) Place the Log 02-75 on the rear log support
pins with the fl at side to the back.
02-75
®
Regency
PG36D Gas Log Fireplace
02-52
02-54
Advertisement
Table of Contents
