Things To Know - Component Failure Identifications - Quantum StorNext QD7000 Installation Manual

124 | E5600 Controller-Drive Tray and Related Drive Trays Installation Guide
Category
Component failure
Diagnostic failure
Category delimiter
End-of-sequence
delimiter
Note:
1
A two-digit code that starts a dynamic display sequence.
2
A two-digit code that follows the category code with more specific information.
3
The plus (+) sign indicates that a two-digit code appears and the Diagnostic LED is turned on.
4
No codes display, and the Diagnostic LED is off.

Things to know - Component failure identifications

Use the seven segment-display values to identify the component.
Table 38: Failure identifications
Component
1
Code
Processor DIMM (dx +
Cache DIMM (CX +)
Host Card (HX +)
Flash Drive (FX +)
Category Detail Codes
1
Code
CF+
• dx+ = Processor or cache DIMM.
• Cx = Cache DIMM.
• Px+ = Processor DIMM.
• Hx+ = Host interface card.
• Fx+ = Flash drive.
• bl + Base Controller Card
dE+ Lx+ = Lock-down codes (See
down codes
segment display use cases
dash+ The separator between category-detail code pairs is used
when more than one category detail code pair exists in the
(Appears as
sequence.
two short
dashes:
"--").
.
4
blank - The end-of-sequence delimiter is automatically inserted
by the hardware at the end of a code sequence.
Seven-Segment Display Used in this Controller
State
Power-on
Diagnostics
2 3
) yes
yes
yes
no
2
Things to know - Lock-
on page 125 and Things to know - Seven-
on page 127.)
Suspended
yes
yes
yes
no
Operational
no
no
yes
yes