Quantum StorNext QD7000 Replacing Manual
A fan in base system
Hide thumbs
Also See for StorNext QD7000:
- Hardware manual (166 pages) ,
- Installation manual (144 pages) ,
- Upgrade manual (39 pages)
Related Manuals for Quantum StorNext QD7000
Summary of Contents for Quantum StorNext QD7000
- Page 1 Replacing a Fan in Base System StorNext QD7000 Firmware 8.30.xx.xx 6-68561-01 Rev A...
- Page 2 Artico, Be Certain (and the Q brackets design), DLT, DXi, DXi Accent, DXi V1000, DXi V2000, DXi V4000, DXiV-Series, FlexTier, Lattus, the Q logo, the Q Quantum logo, Q-Cloud, Quantum (and the Q brackets design), the Quantum logo, Quantum Be Certain...
- Page 3 Titan RAID controller, only). Refer to the NetApp to Quantum Naming Decoder section for additional information. This section provides the following information: • Audience • Prerequisites • NetApp to Quantum Naming Decoder • Product Safety Statements • Contacts • Comments • Quantum Global Services Audience This manual is intended for storage customers and technicians.
-
Page 4: Netapp To Quantum Naming Decoder
Product Quantum-Storage Description Controller-Drive Tray Base System Quantum uses Base System when referring to a drive tray with the RAID controllers. Drive Tray Expansion Unit Quantum uses Expansion Unit when referring to a drive tray with the environmental services modules (ESMs). - Page 5 Preface E-Series NetApp Product Quantum-Storage Description E5560 or E5660 Quantum StorNext QD7000 (DE6600 4U drive enclosure with E5500 or E5600 RAID controllers) E5460 Quantum StorNext QD6000 (DE6600 4U drive enclosure with E5400 RAID controllers) E5424 Quantum StorNext QS2400 (DE5600 24-drive 2U...
-
Page 6: Product Safety Statements
Preface Product Safety Quantum will not be held liable for damage arising from unauthorized Statements use of the product. The user assumes all risk in this aspect. This unit is engineered and manufactured to meet all safety and regulatory requirements. Be aware that improper use may result in bodily injury, damage to the equipment, or interference with other equipment. - Page 7 Preface Contacts For information about contacting Quantum, including Quantum office locations, go to: http://www.quantum.com/aboutus/contactus/index.aspx Comments To provide comments or feedback about this document, or about other Quantum technical publications, send e-mail to: doc-comments@quantum.com Replacing a Fan in Base System...
-
Page 8: Quantum Global Services
Online Service accounts are free from Quantum. That account can also be used to access Quantum’s Knowledge Base, a comprehensive repository of product support information. Get started at: http://www.quantum.com/customercenter/ For further assistance, or if training is desired, contact the Quantum Customer Support Center: North America 1-800-284-5101 (toll free) +1-720-249-5700... - Page 9 Replacing a Failed Fan Canister in the E5660 Controller-Drive Tray To access this product, go to the NetApp® Support Site at support.netapp.com. Before you replace the fan canister in the E5660 controller-drive tray, gather antistatic protection and a replacement fan canister. ATTENTION Possible equipment damage due to overheating –...
- Page 10 Use the command line interface (CLI) to run the Save StorageArray SupportData command to gather comprehensive support data about the storage array. For more information about this command, refer to the Command Line Interface and Script Commands Programming Guide. NOTE Gathering support data can temporarily impact performance on your storage array. 2.
- Page 11 7. Remove the fan canister from the drive tray by pressing on the tab holding the fan canister in place, and then pulling the fan canister toward you. Figure 2. Removing a Fan Canister 92006-02 1. Fan Canister Handle 8. Use the fan canister handle to pull the fan canister out of the controller-drive tray. 9.
-
Page 12: Trademark Information
14. Does any component have a Needs Attention status? Yes – Click the Recovery Guru toolbar button in the Array Management Window, and complete the recovery procedure. If the problem has not been resolved, contact your Technical Support Representative. No – Go to step 15. 15. -
Page 13: How To Send Your Comments
How to send your comments You can help us to improve the quality of our documentation by sending us your feedback. Your feedback is important in helping us to provide the most accurate and high-quality information. If you have suggestions for improving this document, send us your comments by email to doccomments@netapp.com. To help us direct your comments to the correct division, include in the subject line the product name, version, and operating system.
Need help?
Do you have a question about the StorNext QD7000 and is the answer not in the manual?
Questions and answers