Advertisement
Quick Installation Guide
2.4 Exit Button
Install exit button the door on the inside.
When pressing exit button, all LEDs change from red to green. And then they are off
and on orderly. During five seconds, door lock is open.
At this time, IP-RFL200 sounds beeper one time.
2.5 User Card Registration / Deletion
2.5.1 Make a master card read in IP-RFL200. Green LED is on and beeper sounds one
time. This state is master mode which can register or delete a card.
2.5.2 On master mode, making an unregistered card read in IP-RFL200, green LED is
off and on orderly. With one time of beeper sound, card no. is registered on the
memory of the unit.
Otherwise making a registered card read in IP-RFL200, green LED repeats off and
on twice. Next with one time of beeper sound, card no. is deleted on the memory.
2.5.3 Finishing to register/delete a card, making a master card read in IP-RFL200 and
then coming out of master mode.
At this time, LEDs return red and beeper sounds one time.
2.6 Initializing the IP-RFL200 (Pre-Installation Initialization)
2.6.1 Be on the power.
2.6.2 Be on the power connecting green, white and yellow wire.
2.6.3 All stored cards are initialized. Finishing to initialize the IP-RFL200, LEDs change
red or green. And then all LEDs at off state are on with green color orderly.
At this time, IP-RFL200 sounds beeper three times.
2.6.4 Disconnect green, white and yellow wire from IP-RFL200.
After supplying the power, register again master or user card.
20060201
[IP-RFL200 Initialization]
Proximity Access Controller
2
MAML200HE01
Advertisement
