Hardware Installation - Planet Networking & Communication ICA-4460V User Manual

2.2 Hardware Installation

1. Place the Camera on the ceiling or fix it onto wall
Use three screws to fix the camera onto the ceiling or wall.
2. Plug an Ethernet cable into the camera
Connect the Ethernet cable (not included in the package) to the LAN socket. It is
recommended to use an exterior-grade Ethernet cable that is already waterproof.
There is a yellow warning sticker only on the rear end of the all-in-one cable,
stating the small area is not waterproof while the rest of them are waterproof.
3. Connecting the Ethernet cable to PoE switch
As the camera adopts the IEEE 802.3af standard, the camera's Ethernet cable is able to be
connected to this PoE switch to obtain power.
The camera can be powered on by a PoE switch or DC adapter. However, the DC
adapter is unnecessary when the camera is connected to the PoE switch.
Otherwise, the product may be damaged when the camera is connected to the
PoE switch and power adapter simultaneously.
4. Adjusting the angle of lens:
Adjust the camera's stand to get a proper angle.
5. Done
1080p IR Bullet PoE IP Camera
- 16 -
ICA-4460V