Hardware Installation - Planet Networking & Communication ICA-3250 User Manual

2.2 Hardware Installation

1. Place the Camera on the ceiling or fix it onto wall
Use three screws to fix the camera onto the ceiling or wall.
2. Plug an Ethernet cable into the camera
Connect the Ethernet cable (not included in the package) to the LAN socket. It is
recommended to use an exterior-grade Ethernet cable that is already waterproof.
The rear end of the all-in-one cable is not waterproof where there is a yellow
warning sticker to remind user. Please use a waterproof all-in-one cable.
3. Connecting the Ethernet cable to PoE switch
As the camera adopts the IEEE 802.3af standard, the camera's Ethernet cable is able to be
connected to this PoE switch to obtain power.
The camera supports can be powered on by a PoE switch or DC adapter.
However, the DC adapter is unnecessary when the camera is connected to the
PoE switch. Otherwise, the product may be damaged when the camera is
connected to the PoE switch and power adapter simultaneously.
4. Adjusting the angle of lens:
Adjust the camera's stand to get a proper angle.
5. Done
1080p IR Bullet PoE IP Camera
- 15 -
ICA-3250