Hardware Install Procedure - Planet Networking & Communication ICA-101 User Manual

Internet Camera User Guide

Hardware Install Procedure

1.Connect an Ethernet cable
Connect one end of an Ethernet cable to the LAN port located on the ICA-101/101W
rear panel and attach the other end to the network device (hub or switch). If you want
to use wireless connection for ICA-101W, you can skip this step.
2.Attach the external power supply
Connect the provided power adapter to the ICA-101's connector labeled "5VDC" on
rear panel.
3.Check the LEDs
The PWR would flash for few seconds to detect network connection. The network
indication LEDs (LAN or WLAN) would be on depending on which network type is
available.
6