Liabilities - DeDietrich ALEZIO S V200 User Manual

1.9

Liabilities

Manufacturer's li­ Our products are manufactured in compliance with the requirements of the various Directives applicable.
ability
They are therefore delivered with the
quality of our products, we strive constantly to improve them. We therefore reserve the right to modify the
specifications given in this document.
Our liability as manufacturer may not be invoked in the following cases:
Failure to abide by the instructions on installing the appliance.
Failure to abide by the instructions on using the appliance.
Faulty or insufficient maintenance of the appliance.
Installer's liability The installer is responsible for the installation and initial commissioning of the appliance. The installer must
observe the following instructions:
Read and follow the instructions given in the manuals provided with the appliance.
Install the appliance in compliance with prevailing legislation and standards.
Carry out initial commissioning and any checks necessary.
Explain the installation to the user.
If maintenance is necessary, warn the user of the obligation to check the appliance and keep it in good
working order.
Give all the instruction manuals to the user.
User's liability To guarantee optimum operation of the system, you must abide by the following instructions:
Read and follow the instructions given in the manuals provided with the appliance.
Call on a qualified professional to carry out installation and initial commissioning.
Get your installer to explain your installation to you.
Have the required inspections and maintenance carried out by a qualified installer.
Keep the instruction manuals in good condition close to the appliance.
7682850 - v04 - 02082019
Removal and disposal of the heat pump must be carried out by a qualified
professional in accordance with prevailing local and national regulations.
After maintenance or repair work, check the entire heating system to
ensure that there are no leaks.
Remove the casing only to perform maintenance and repair work. Put the
casing back in place after maintenance and repair work.
The user must make sure the refrigerant pipes are checked annually for
leaks for any heat pump with a charge greater than 5 tonnes of CO
equivalent.
marking and any documents necessary. In the interests of the
1 Safety instructions and recommendations
MIV-4S V200
2
9