Liabilities - DeDietrich ALEZIO S V200 User Manual

1.9

Liabilities

Tab.1
Manufacturer's liability
Installer's liability
User's liability
7748661 - v03 - 08062020
Wait for approx. 20-30 seconds for the outdoor unit capacitors to be
discharged, and check that the lights on the outdoor unit PCBs have gone
out.
Before working on the refrigeration circuit, switch off the appliance and
wait a few minutes. Certain items of equipment such as the compressor
and the pipes can reach temperatures in excess of 100°C and high
pressures, which may cause serious injuries.
Locate and correct the cause of power cut before resetting the safety
thermostat.
Only genuine spare parts may be used.
Removal and disposal of the heat pump must be carried out by a qualified
professional in accordance with prevailing local and national regulations.
After maintenance or repair work, check the entire heating system to
ensure that there are no leaks.
Remove the casing only to perform maintenance and repair work. Put the
casing back in place after maintenance and repair work.
For heat pumps with a refrigerant fluid load of more than 5 tonnes of CO
equivalent, the user must have an annual leak-tightness test performed on
the refrigerant equipment.
Our products are manufactured in compliance with the requirements of the various Di­
rectives applicable. They are therefore delivered with the
ments necessary. In the interests of the quality of our products, we strive constantly to
improve them. We therefore reserve the right to modify the specifications given in this
document.
Our liability as manufacturer may not be invoked in the following cases:
Failure to abide by the instructions on installing the appliance.
Failure to abide by the instructions on using the appliance.
Faulty or insufficient maintenance of the appliance.
The installer is responsible for the installation and initial commissioning of the appliance.
The installer must observe the following instructions:
Read and follow the instructions given in the manuals provided with the appliance.
Install the appliance in compliance with prevailing legislation and standards.
Carry out initial commissioning and any checks necessary.
Explain the installation to the user.
If maintenance is necessary, warn the user of the obligation to check the appliance
and keep it in good working order.
Give all the instruction manuals to the user.
To guarantee optimum operation of the system, the user must abide by the following in­
structions:
Read and follow the instructions given in the manuals provided with the appliance.
Call on a qualified professional to carry out installation and initial commissioning.
Ask your installer to explain your installation to you.
Have the required inspections and maintenance carried out by a qualified installer.
Keep the instruction manuals in good condition close to the appliance.
1 Safety instructions and recommendations
marking and any docu­
MIV-S V200
2
9