Arctic Cat PROWLER XT 2014 Service Manual page 189

4. Install the input shaft into the pinion housing; then
secure in the bearing with a circlip.
5. Place the pinion housing with new gasket onto the
differential housing; then secure with existing cap
screws. Tighten to 23 ft-lb.
 NOTE: If a new differential housing is being
installed, tighten the cap screws to 28 ft-lb.
Disassembling Differential
Assembly
 NOTE: This procedure can be performed on a rear
gear case.
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing. Account for the coupler,
fork, and spring (differential only).
186
2. Using a T-40 torx wrench, remove the cap screws
securing the differential cover. Account for and make
GC009A
note of the ID tag location for assembling purposes.
3. Using a plastic mallet, tap lightly to remove the dif-
ferential cover. Account for an O-ring.
KX209
 NOTE: If the cover is difficult to remove, pry on the
cover in more than one recessed location.
GZ004A
4. Remove the splined coupler, shifter fork, pin, and
spring of the differential lock assembly and set aside.
Note position of parts for assembling purposes.
GC015
GC003
KX174