Advertisement
Auto-Lock Kit - R1N Installation instructions
led status
lock position status
The status normally displays for 10secs
after lock movement / button press.
troubleshooting
Symptom
door not moving and no lights
on lock
lock is not unlocking and
preventing doors movement
red and green lights both on
solid on the lock.
one lock has lights the other
lock has no lights
red and green lights on one
lock flashing slowly
red and green lights flashing
alternatively
battery change
a. Replace lock batteries (2 x C-LR 14) immediately when the
Auto-lock LED's red and green lights flash 3 times or are
flashing slowly.
b. Remove cover by unscrewing the four screws on the main
cover.
c. Replace batteries, refit cover and secure with screws.
d. Operate opener to complete a full open / close cycle and
ensure Auto-lock engages.
WARRANTY
ACCESSORIES
If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure. This warranty certificate and other statements contained in this document or other B&D documents given to you do not
exclude, restrict or modify the application of all or any of the provisions of the Australian Consumer Law.
Subject to your non-excludable rights under the Australian Consumer Law, B&D expressly excludes any liability for consequential loss, incidental or indirect damages (including but not limited
to damages for loss of business profits, business interruption and loss of business information) due to a defect of the Product. In particular, any loss or damage caused to other equipment or
accessories used with the product or any loss resulting from a delay in repair is excluded to the extent permitted by law.
b&d group office locations
Head Office
6-8 Fiveways Blvd, Keysborough 3173
New South Wales
34 Marigold St, Revesby 2212
Queensland
17 Oasis Court, Clontarf 4019
Victoria
147-153 Canterbury Rd, Kilsyth 3137
South Australia
23 Frederick Rd, Royal Park 5014
Western Australia
96 Mulgul Rd, Malaga 6090
International/Export
34 Marigold St, Revesby 2212
New Zealand
46 Braeburn Dr, hornby, Chch 8082
Prefixed trademarks are the property of B&D Australia Pty Ltd. B&D Doors & Openers
is a division of B&D Australia Pty Ltd. ABN 25 010 473 971. © 2016 B&D Australia Pty Ltd.
www.bnd.com.au
FLASHING RAPIDLY
FLASHING SLOWLY
FLASHING ALTERNATIVELY
Possible cause
Remedy
limited battery
press the (i) button on the lock to see if there is power in the battery.
power
no lights - change battery
lights - check LED status table.
lock jammed
ensure the lock bracket is square to the guide (if not use packers). Check if there is
anything obstructing the lock bolt movement. Press the unlock button on each lock.
If it does not move call 13 62 63.
error with lock
press the unlock button on the lock to test operation.
switch off power to opener, then switch back on after 30 secs (If a battery backup is
installed press & hold STOP/SET button on the opener until power ceases). Press the
lock/ unlock button on the lock to test operation. If it does not move call 13 62 63.
limited battery
press the (i) button on the lock without lights to see if there is power in the battery.
power
no lights - change battery
lights - check LED status table.
low battery
change battery, then test operation of lock by pressing the lock / unlock button.
no link to opener
Disconnect power to the opener and check connection of the basestation harness
to the control board.
Refer to our website for full warranty details;
1 year
www.bnd.com.au/repairs-service/door-warranty
Phone (03) 9791 0200
Phone (02) 9722 5555
Phone (07) 3883 0200
Phone (03) 9237 7766
Phone (08) 8440 4747
Phone (08) 9247 8777
Phone +61 (0)2 9722 5555
Phone +64 (0)3 384 5145
LED STATUS INDICATORS
RED
GREEN
ON
FLASHING RAPIDLY
ON
ON
ON
FLASHING SLOWLY
FLASHING ALTERNATIVELY
6
LOCK STATUS
LOCKING
LOCKED
UNLOCKING
UNLOCKED
ERROR
LOW BATTERY
NO LINK WITH BASESTATION
Remove screws to
open main cover
your representative is
Advertisement
