Advertisement
Auto-Lock Kit - R1N Installation instructions
limited side room installation for Roll-A-Door Neo
(front mount)
X
a. After limits are set on the opener,
measure the position
lock striker from the ground to
the middle of the lock striker. (as
shown).
b. Once
both
lock
installed, test manual operation
of the door to ensure no sticking
or scraping within the guide.
11
f. Remove the old head stop and
replace with longer head stop
g. Unscrew the bottom rail stop on
each side of the door and move
into the inner hole and refit screw
as shown.
c. Open the door, place some
tape inside each guide and
of each
X
transfer measure
of guide.
d. Using an 18mm stepped drill,
strikers
are
drill a hole through the guide
and remove any burs from hole.
lock bolt flush with
inside of guide
mark
front view
h. Place bracket on wall up against
.
the guide and ensure the body of
11
the lock bolt is flush with the inside
of the guide.
i. Mark the position of the bracket
holes on the wall. Predrill holes and
affix to wall with 2 x coach screws
and washers. (not supplied)
mark
X
to middle
X
side view
2
8
e. Assemble both AutoLocks
wall brackets
using 2 x button
8
head screws
, ensuring the flat
2
side of the lock bolt is facing the
door.
side view
j. With the door closed, test the
operation of each AutoLock by
pressing the lock/unlock button to
ensure the lock bolt fully engages
through the guide and into the
striker without interference.
PROCEED TO CONNECTING WIRELESS
BASE STATION TO THE OPENER.
4
1
to the
1
lock bolt
engages without
interference
Advertisement
