Advertisement
Auto-Lock Kit - R1N Installation instructions
connect basestation to opener
Grommet
a. Disconnect the power supply to the opener.
b. Remove the light diffuser via screw at the bottom.
c. Remove the grommet out of the back cover.
d. Cut (1) one side of the grommet with a knife or scissors.
e. Connect harness to basestation
the cut in the grommet.
f. Refit grommet to back cover by inserting the harness
through hole before fitting grommet.
If a PE Beam is installed ensure that the channels on the basestation on each device are different.
tip
The channel on the basestation can be changed by sliding the switch in either direction
emergency operation
Press the emergency lock/unlock button on the front of each Auto-Lock
to disengage the locking bolt from the guide track and allow you to
disengage the opener and open the door.
WARNING! The emergency lock/unlock button on
this product is not to be used as a primary means of
locking the door under normal circumstances.
The emergency lock/unlock button is to be used only in case of power
outage or emergency.
Light diffuser
screw
ACC Pin
, before sliding into
5
5
g. Place the velcro
onto the basestation
6
to the back of the opener as shown.
h. Connect the harness to the ACC 4 pin on the control
board.
i. Refit the light diffuser.
j. Reconnect power to the opener and test operation via
the opener.
k. Upon completion of a full cycle the lock will engage
into the track.
5
Light diffuser
and secure
5
.
Advertisement
