Advertisement
Auto-Lock Kit - R1N Installation instructions
standard installation for Roll-A-Door Neo
(side mount)
X
a. After limits are set on the opener,
measure the position
lock striker from the ground to
the middle of the lock striker as
shown.
mark
e. Place bracket on wall up against the guide and
ensure the body of the lock bolt is flush with the
inside of the guide.
f. Mark the position of the bracket holes on the wall.
Predrill holes and affix to wall with 2 x coach screws
and washers. (not supplied)
b. Open the door, place some
of each
tape inside each guide and
X
transfer measure
of guide.
c. Using an 18mm stepped drill,
drill a hole through the guide
and remove any burs from hole.
lock bolt flush
with inside of
guide
mark
X
to middle
X
g. With the door closed, test the operation of each
AutoLock by pressing the lock/unlock button to
ensure the lock bolt fully engages through the guide
and into the striker without interference.
PROCEED TO CONNECTING WIRELESS BASE STATION TO
THE OPENER.
1
8
d. Assemble both AutoLocks
wall brackets
using 2 x button
8
head screws
, ensuring the flat
2
side of the lock bolt is facing the
door.
lock bolt
engages without
interference
3
2
to the
1
Advertisement
