Getting Started - K&S BASIC KSB 22i S Owner's Manual

Recommended fuel: Recommended fuel: only unleaded gasoline is recommended for the generator.
Fuel tank volume: Fuel tank volume: see specifications table.
IMPORTANT!
IMPORTANT!
CHECKING THE OIL LEVEL CHECKING THE OIL LEVEL
The generator is transported free of motor oil. Do not start the engine until it is filled with sufficient amount
of motor oil.
1. Unscrew the oil dipstick and wipe it out with a clean cloth.
2. Insert the dipstick without screwing it in.
3. Check the oil level by a mark on the oil dipstick.
4. Add oil if its level is below the mark on the oil dipstick.
5. Screw on the dipstick.
Recommended motor oil: SAE 10W30, SAE 10W40. Recommended motor oil:
Recommended motor oil grade: Recommended motor oil grade: API Service SG type or higher.
Motor oil quantity: Motor oil quantity: see specifications table.
Before starting the engine, Before starting the engine, make sure that the rated power of power consumers matches with the power of generator.
Do not exceed the nominal power of the generator. Do not connect any devices before you start the engine!
IMPORTANT!
ATTENTION – DANGER!
COMMISSIONING COMMISSIONING
1. Fill the crankcase with engine oil. The recommended amount of oil for each model is indicated in the specification
chart.
2. Check oil level with an oil dipstick. It should be between the MIN and MAX marks on the oil dipstick.
3. Check fuel level.
4. Check the air filter for correct installation
In the first 20 operating hours of the generator, the following requirements should be met:
1. During commissioning, do not connect power consumers, the power of which exceeds 50% of the nominal
(operating) power of the device.
2. After the first 20 operating hours, be sure to change the oil. It is better to drain oil while the engine is still hot after
operation to ensure quick and complete oil draining.
3. Check and clean the air filter, fuel filter and spark plug.
IMPORTANT!
Wipe up spilled fuel immediately with a clean, dry, soft cloth, as
the fuel may harm painted surfaces or plastic parts.
Use only unleaded gasoline. Using leaded gasoline can cause
serious damage to the inside of the engine.
Do not connect any devices before you start the engine!
Do not change the controller settings in terms of the amount
of fuel or speed governor (this adjustment was made at the
factory). Otherwise, this may result in changes in the engine
operation or its failure.
In the power supply mode, the generator should operate no
longer than 1 minute in the range from nominal to maximum
power.
Before starting the generator, connect the ground wire to the
ground terminal.

GETTING STARTED

www.ks-power.de/en
FILL TO HERE FILL TO HERE
7
| 5