Configure Hdd; Configure Signal Input - HIKVISION DS-7216HGHI-K1 User Manual

2. Select Working Mode as Net-Fault Tolerance or Multi-Address Mode.
Net-Fault Tolerance
The two NIC cards use the same IP address, and you can select the main NIC to LAN1 or LAN2.
In this way, in case of one NIC card failure, the device will automatically enable the other
standby NIC card so as to ensure the normal running of the system.
Multi-Address Mode
The parameters of the two NIC cards can be configured independently. You can select LAN1
or LAN2 under Select NIC for parameter settings. Select one NIC card as the default route.
When the system connects with the extranet, the data will be forwarded through the default
route.
3. Configure other IP settings as needed.
4. Click Apply.
Note
● Check Enable DHCP to obtain IP settings automatically if a DHCP server is available on the
network.
● Valid MTU value range is 500 to 9676.

1.3 Configure HDD

Ensure the video recorder storage media is well. You can install at least one HDD and initialize it,
or create a RAID and initialize it.

1.4 Configure Signal Input

You can configure the analog and IP signal input types, disabling one analog channel can add one
Digital Video Recorder User Manual
Figure 1-8 TCP/IP Settings
7