Mercury GO BOLDLY SeaPro 500hp Operation And Maintenance Manual page 63

Table of Contents

Advertisement

FEATURES AND CONTROLS
Low engine oil level. Refer to Fuel and Oil ‑ Checking and Adding
Engine Oil.
ENGINE GUARDIAN SYSTEM
The Engine Guardian system monitors the critical sensors on the engine for
any early indications of problems. Engine Guardian is functional whenever your
engine is operating, so you never have to be concerned about whether or not
you are protected. The system will respond to a problem by sounding the
warning horn for six seconds and/or reducing engine power in order to provide
engine protection.
If Engine Guardian has been activated, reduce the engine speed. The problem
will need to be identified and corrected. The system must be reset before the
engine will operate at higher speeds. Moving the throttle lever back to the idle
position will reset the Engine Guardian system. If the Engine Guardian system
has determined the reset has not corrected the problem, Engine Guardian will
remain activated, limiting the throttle. The problem must be identified and
corrected before Engine Guardian will allow the engine to reach a normal
operating RPM.
OVERSPEED REV LIMIT
The overspeed rev limit is set at an RPM greater than the operating range. In
the event that the engine is operated at an RPM greater than or equal to the
overspeed limit, the PCM does not allow the engine to maintain the power
requested by the operator. Refer to General Information ‑ Specifications to
determine this engine's RPM limit.
Upon reaching the beginning of the overspeed rev limit, Engine Guardian will
cut fuel to one bank of cylinders. If the operator does not reduce engine speed,
Engine Guardian will cut the fuel to all cylinders until the engine speed has
dropped below the rev limit. There is no audible warning while Engine Guardian
overspeed limit is active.
SMARTCRAFT PRODUCT
A Mercury SmartCraft System instrument package can be purchased for this
outboard. A few of the functions the instrument package will display are engine
RPM, coolant temperature, oil pressure, water pressure, battery voltage, fuel
consumption, and engine operating hours.
The SmartCraft instrument package will also aid in Engine Guardian
diagnostics. The SmartCraft instrument package will display critical engine
alarm data and potential problems.
eng
53

Advertisement

Table of Contents
loading

Table of Contents