Mercury GO BOLDLY SeaPro 500hp Operation And Maintenance Manual page 25

Table of Contents

Advertisement

Attribute
Gearcase type
Gearcase lube capacity
Transmission shift type
Shift control—helm compatibility
Transmission fluid capacity with filter
change
Transmission fluid capacity without
filter change
Overall gear ratio—forward
Recommended gasoline
Recommended oil
Engine oil capacity with oil filter
replacement
Required battery type
Battery rating***
*Engine at normal operation temperature.
**The idle charge compensation may automatically increase the engine speed
up to 825 RPM to compensate for a low battery charge condition. The
increased idle RPM will charge the battery at a higher rate. Activating troll
control (optional accessory) will override the idle charge compensation
feature.
***Battery manufacturers may rate and test their batteries to different
standards. MCA, CCA, Ah, and reserve capacity (RC) are the ratings
recognized by Mercury Marine. Manufacturers that use standards different
than these, such as equivalent MCA, do not meet Mercury Marine battery
requirements.
eng
GENERAL INFORMATION
USA (SAE)
International (EN)
SeaPro 500hp V12
165 mm (6.5 in.)
Contra‑rotation dual prop
2.8 L (3.0 US qt)
2‑speed with wet clutches
DTS only
6.6 L (7.0 US qt)
5.7 L (6.0 US qt)
Refer to Fuel and Oil
Refer to Fuel and Oil
13.25 L (14.0 US qt)
12‑volt absorbed
glass mat (AGM) battery
1000 minimum marine cranking amps
(MCA) with a minimum reserve
capacity of 135 RC25 rating
800 minimum cold cranking amps
(CCA) with a minimum 65‑amp hour
15
2.50:1
(Ah)

Advertisement

Table of Contents
loading

Table of Contents