Oce 7050 Technical & Service Manual page 224

TSM Océ 7050
Z-0030 Introduction
GROUPS:
- An illustration (exploded view) and a list of which the indexes
refer to the illustration, subdivided in:
- INDEX:
- The indexnumber refers to the shown parts in the illustration.
Indexnumbers that are placed on the right, occur in the illustration.
Indexnumbers that are placed on the left, do not occur in the
illustration.
- The characters A through K (except I) behind the indexnumber
indicate the item as a replaced part.
- The characters L through Z (except O) are additional and can be
seen as a normal indexnumber.
- PART NO.:
- The partnumber of the concerning part.
- DESCRIPTION:
- The description of the concerning part.
Description prefaced with "-" is a part of the preceding assy part
of group.
- Description prefaced with "- -" is a part of the preceding assy part.
Description prefaced with "- - -" is a part of the preceding assy
part.
Edition: 6 Date: 04-2001 Confidential © 2001 Océ-Technologies B.V.
- QTY ASSY:
- In this or these column(s) the quantity of the concerning part is
indicated.
- GROUPNUMBER, EDITION AND DATE:
- At the bottom of the concerning group the groupnumber, edition
and date are mentioned; these are the same in the illustration and
in the list.
The pagenumbering is also mentioned.
FASTENING MATERIALS:
- All fastening materials that are standard and used in the
concerning machine(s) are taken up in this collective list
(Z-2570).
TOOLS:
- All special tools needed by technicians to service the machine
are taken up in this list (Z-2550).
ORDERING PARTS:
When ordering parts state the following data:
- type of the machine (Océ 7050)
- partnumber
- description and quantity of the desired part.
Partslist
Z-0030 Introduction