Ford 1996 Contour Manual page 165

Jump-Starting
Make sure that the jumper cables are not in the way of
1.
moving engine parts, then start the booster vehicle. Run the
engine at a moderate speed.
Let the discharged battery charge for a few minutes and then
2.
start the disabled vehicle. It may take a couple of tries before
the vehicle starts. If the vehicle does not start after several
attempts, there may be a different problem.
When both vehicles are running, let them idle for a few
3.
minutes to charge the discharged battery.
Removing jumper cables
Always remove the jumper cables in the reverse order.
1.
Remove the negative (–) end of the jumper cable from the
metallic surface on the engine or frame of the disabled
vehicle.
Remove the negative (–) cable from the booster battery.
2.
Remove the positive (+) cable from the booster battery.
3.
Remove the other end of the positive (+) cable from the
4.
discharged battery.
After the vehicle is started, let it idle for a while to let the
engine "relearn" its idle conditions. Drive it around for a while
with all electrical accessories turned off to let the battery
recharge. You may need to use a battery charger to fully
recharge the battery.
If you need to replace your battery, see Battery in the Servicing
Your Vehicle chapter.
Roadside Emergencies
167