Ford 1996 Contour Manual page 118

6
Using the "SCAN/TUNE" button to scan radio stations
Pressing the "SCAN/TUNE" button once enters the scan
mode (display will indicate "SCN"). Pushing the top a half
of the "SEEK" button will begin the scan mode up the
frequency band, stopping on each listenable station for
approximately five seconds. Pushing the bottom b half of
the "SEEK" button will begin the scan mode down the
frequency band, again stopping on each listenable station for
approximately five seconds.
To stop the scan mode on the presently sampled station
press the "SCAN/TUNE" button again.
Setting the Station Memory Preset buttons
Your radio is equipped with 6 station memory buttons.
These buttons can be used to select up to 6 preset AM
stations and 12 FM stations (6 in FM1 and 6 in FM2).
Select a band, then select a frequency.
1.
Press one of the memory buttons and hold the button until
2.
the sound returns. That station is now held in memory on
that button.
Follow the two steps above for each station memory preset
3.
button you want to set.
NOTE: If the vehicle's battery is disconnected, the clock and
Using the Automatic Memory Store feature
With Auto Memory Store, you can continually set strong
stations into your memory buttons without losing your
existing memory presets, which is especially handy while
traveling. Your radio will automatically set your memory
buttons to the strong local stations so you don't have to
continually manually tune to existing stations.
118
station memory preset buttons (if programmed in auto
mode) will need to be reset.