Fahl NEBUFIRST Instructions For Use Manual page 29

Inhaler
Hide thumbs Also See for NEBUFIRST:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24
2.0 SAFETY INFORMATION
The device must not be taken into operation:
if the power supply cable or the connection socket are damaged,
if the device has fallen down,
if the device shows obvious safety defects.
Clean the device and return it for repair via the dealer from whom you have purchased the NEBUFIRST
The device must be checked at regular intervals for proper function and technical safety defects, e.g. plug contacts, housing, etc.
The ambient conditions specified in Section 1.5 ‚Transport and storage' must be observed.
Never immerse the device in water, even when the device is in non-activated state.
Before starting up the device, the device itself and accessories must be checked for damages. Ventilation slits should not be
obstructed. The device must be checked for proper function before use.
No liquid must be allowed to penetrate into the device. If liquid has penetrated into the device, then the device must only be taken
into operation again after it has been checked by the customer service. Damaged accessories must be replaced immediately.
The device must be set up on a firm, level surface. If the device is set up on an uneven surface (e.g. mattress, cushion,
upholstered chair), there is a risk that the device may tip.
Before the device is connected, it must be checked whether the mains voltage and frequency indicated on the device are the
same as the voltage and frequency of the supply network.
Only use proper mains connections and extension cables. Avoid moisture on plug and switch unit.
N
EQUIPMENT DAMAGE!
29
INHALER.
®
EN

Advertisement

Table of Contents
loading

Related Products for Fahl NEBUFIRST

Table of Contents