Using The Remote Control Unit - Sharp PN-80TH5 Operation Manual

Basic Operation

Using the remote control unit

1
2
3
4
5
6
7
8
9
10
1. HDMI
Switch the input mode to HDMI1, HDMI2 or HDMI3.
2. Numeric input buttons
Use for the following tasks. (0 to 9)
• To set the remote control number.
• To set the IP ADDRESS, SUBNET MASK, and DEFAULT
GATEWAY.
3. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
26
E
4. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB →
11
HIGH ILLUMINANCE → STD...
12
• HIGH ILLUMINANCE is a display with colors suited to
13
bright locations.
• sRGB cannot be used when input mode is D-SUB[COMPONENT].
sRGB is international standard of color representation
specified by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal's characteristics and represents color tone
close to its original image.
5. VOLUME +/- (Volume adjustment)
14
Pressing + or - displays the VOLUME menu.
23
15
16
17
18
19
20
Press + or - to adjust the volume.
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.