Sharp PN-80TH5 Operation Manual page 13

8. DisplayPort output terminal
• The screen displayed on this monitor and the audio output
from this monitor can be output to an external device.
• Use a commercially available DisplayPort cable
(conforming to the DisplayPort standard) that supports
4K.
• Outputting HDCP-encrypted video requires an external
device which supports HDCP.
• Output of video may not be possible with some versions
of HDCP.
9. Audio output terminal
• The output sound varies depending on the input mode.
• The volume of the output sound can be fixed by setting
AUDIO OUTPUT of AUDIO OPTION on the SETUP
menu.
• It is not possible to control the sound output from the
audio output terminals with the AUDIO menu.
10. Touch pen adapter port
• Connect the touch pen adapter in order to use the touch
pen. (See page 19.)
11. USB 1 port (for touch panel)
• To use the touch panel with a computer connected to the
terminal below, connect the touch panel to the computer
with a USB cable.
(Factory setting. Can be changed in TOUCH INPUT
SELECT on the SETUP menu.)
- DisplayPort 1 input terminal
- HDMI 1 input terminal
12. USB 2 port (for touch panel)
• To use the touch panel with a computer connected to the
terminal below, connect the touch panel to the computer
with a USB cable.
(Factory setting. Can be changed in TOUCH INPUT
SELECT on the SETUP menu.)
- D-sub input terminal
- DisplayPort 2 input terminal
- HDMI 2 input terminal
- HDMI 3 input terminal
13. USB port
• Use to connect a device when using Pen Software multi-
board mode (optional). To build a system, consult your
dealer.
14. RS-232C input terminal
• The monitor can be connected to a computer using the
RS-232C conversion cable (supplied) and a commercially
available RS-232 straight cable to control the monitor
from the computer.
15. LAN terminal
• You can control the monitor from a computer on a network
by connecting a commercially available LAN cable
between this terminal and a network.
Connecting Peripheral Equipment
16. External speaker terminals
• To use external speakers, set SPEAKER SELECT to
EXTERNAL in AUDIO OPTION on the SETUP menu.
• Be sure to use external speakers with an impedance of 6 Ω
or greater and a rated input of at least 10 W.
1
1. While pushing the tab, insert the tip of the cable.
2. Release the tab.
TIPS
• Be sure to connect the + and - terminals and the left and
right speakers properly.
• Avoid short circuiting the + and - terminals.
• When SPEAKER SELECT is set to EXTERNAL, the
internal speakers are disabled.
17. USB cable
• To use the USB port (for USB device) (USB 2.0 compliant)
on the front of the tray, connect the USB cable to the USB
port on the computer.
USB port (for USB device)
* The touch panel must be connected separately.
2
Computer
13
E